Just bought a brand new 2019 Logan Access (comes with no radio)
Dashboard as received
I decided to fit a double din rather than the single version as I think it looks better (more expensive option though)
1. Plastic trim removal tools, and window winder tool.
2. Kenwood DPX7100DAB radio (comes with DAB aerial)
3. Connects2 Fascia adaptor CT23DC09 (Piano black)
4, Connects2 DIN Harness adaptor CT20DC01
5. Connects2 Analogue Aerial adaptor CT27AA01
6. Kenwood KFC-S1756 Ø6.5" 500watt Speakers (pair)
7. Connects2 Dacia Ø6.5" Speaker adaptors CT25DC01 (pair)
8. Kenwood KFC-S1356 Ø5.25" 260watt Speakers (pair)
9. Connects2 Renault Ø5.25" Speaker adaptors CT25RT02.
10. Renault Door trim panel clips (x10) 770307746
11. Connects2 Speaker harness CT55-DC01 (pair)
12. 5m of speaker wire
13. Selection of 6.3mm spade crimps
14. Self adhesive plastic hooks
15. Selection of small rubber grommets
Begin by prising off the genuine imitation carbon fibre radio surround, start at the bottom and work up. Use the plastic removal tools to avoid damaging the thing. Disconnect the Hazard switch from its harness.
Connect all the wires to the back of the radio and screw it into the dash using the four torx screws from the cubby hole.
I'd advise not replacing the carbon fibre surround until you've tested the radio and speakers but here it is.
Now prise out the door clips from the bottom of the doors using the removal tools, try to pull them out squarely to reduce breakages. Start at the bottom and work your way up.
Once the clips are out lift the door cars upwards to remove them, the front door cards will need to be tilted towards the car at the same time.
Only the drivers door had a wiring harness, removing the rubber plug on the front passenger side revealed that connector.
With the exception of the drivers door, carefully route the cables through the doors to appear close to the speaker holes. Use one of the adhesive plastic clips to hold the wire away from the window. Wind the window up and down to make sure.
Now bolt the speaker spacers to the doors, the foam should act as a waterproof seal. Connect the speakers to the wires and screw the speakers into the adaptors.